Danfoss VLT AutomationDrive FC 301 Programming Manual page 210

Parameter Descriptions
23-14 Maintenance Date and Time
Array [20]
Range:
Size [ 0 -
related 0 ]
*
3 3
23-15 Reset Maintenance Word
Option:
[0] Do not
*
reset
[1] Do
reset
208
Function:
Set the date and time for next maintenance
occurrence if the preventive maintenance
event is based on date/time. Date format
depends on the setting in
parameter 0-71 Date Format while the time
format depends on the setting in
parameter 0-72 Time Format.
NOTICE
The frequency converter has no back-
up of the clock function and the set
date/time is reset to default
(2000-01-01 00:00) after a power-down.
In parameter 0-79 Clock Fault, it is
possible to program a warning if the
clock has not been set properly, for
example after a power-down.
Set the time at least 1 hour later than
actual time.
NOTICE
®
When mounting a VLT Analog I/O
option MCB 109 option card, a battery
back-up of the date and time is
included.
Function:
NOTICE
When messages are reset - maintenance
item, action, and maintenance date/time
are not canceled.
Parameter 23-12 Maintenance Time Base is
set to [0] Disabled.
Set this parameter to [1] Do reset to reset the
maintenance word in parameter 16-96 Maintenance
Word and reset the message shown in the LCP.
This parameter changes back to [0] Do not reset
when pressing [OK].
Danfoss A/S © 01/2018 All rights reserved.
®
VLT AutomationDrive FC 301/302
23-16 Maintenance Text
Array [6]
Range:
0 [0 -
*
20 ]
Function:
6 individual texts (Maintenance Text
0...Maintenance Text 5) can be written for use in
either parameter 23-10 Maintenance Item or
parameter 23-11 Maintenance Action.
The text is written according to the guidelines in
parameter 0-37 Display Text 1.
MG33MO02