Changing Data; Changing A Text Value; Changing A Group Of Numeric Data Values; Changing Of Data Value, Step-By-Step - Danfoss VLT HVAC Drive FC 102 Operating Instructions Manual

How to Programme
Group no. Parameter group
27-** Cascade CTL Option
29-** Water Application Functions
31-** Bypass Option
Table 6.7 Parameter Groups
After selecting a parameter group, select a parameter with
the navigation keys.
The middle section on the GLCP display shows the
parameter number and name as well as the selected
parameter value.
740RPM
Basic Settings
0 -01 Language
[0] English
Illustration 6.19 Display Example

6.1.7 Changing Data

1. Press [Quick Menu] or [Main Menu] key.
▲ ▼
2.
Press [ ] and [ ] to find parameter group to edit.
3. Press [OK] key.
▲ ▼
4.
Press [ ] and [ ] to find parameter to edit.
5. Press [OK] key.
▲ ▼
6.
Press [ ] and [ ] to select correct parameter
setting. Or, to move to digits within a number,
press keys. Cursor indicates digit selected to
▲
change. [ ] increases the value, [
value.
7. Press [Cancel] to disregard change, or press [OK]
to accept change and enter new setting.

6.1.8 Changing a Text Value

If the selected parameter is a text value, change the text
▲ ▼
value with the [ ]/[ ] keys.
▲ ▼
[ ] increases the value, and [
the cursor on the value to be saved and press [OK].
MG16B202
Operating Instructions
10.64A 1 [1]
0-0 *
▼
] decreases the
] decreases the value. Place
Danfoss A/S © Rev. 06/2014 All rights reserved.
740RPM
Basic Settings
0 -01 Language
[0] English
Illustration 6.20 Display Example
6.1.9 Changing a Group of Numeric Data
Values
If the selected parameter represents a numeric data value,
change the selected data value with the [◄] and [►] keys
▲ ▼
as well as the up/down [ ] [
move the cursor horizontally.
113 RPM
Load depen. setting
1 - 60 Low speed load
compensation
100%
Illustration 6.21 Display Example
▲ ▼
Press [ ] and [ ] to change the data value. [
▼
the data value, and [ ] decreases the data value. Place the
cursor on the value to be saved and press [OK].
729RPM
Load depen. setting
1 - 60 Low speed load
compensation
1 0% 6
Illustration 6.22 Display Example
6.1.10 Changing of Data Value, Step-by-
Step
Certain parameters can be changed step by step or
infinitely variably. This applies to parameter 1-20 Motor
Power [kW], parameter 1-22 Motor Voltage and
parameter 1-23 Motor Frequency.
The parameters are changed both as a group of numeric
data values and as numeric data values infinitely variably.
10.64 A 1 [1]
0-0 *
] keys. Press [◄] and [►] to
1.78 A 1(1)
1- 6*
▲
] increases
6.21A 1(1)
1- 6*
89
6 6