Extended Menu Structure; Parameter Numbers; Accessing The Various Parameters; Changing The Parameter Data Value - Danfoss VLT 3500 Series Instruction Manual

Extended Menu Structure

VLT Series 3500 menu structure, referred to as the
Extended Menu, is divided into seven groups. These
contain parameters that allow performance to be
optimized and efficiency to be maximized. Although the
default parameters are acceptable for most applications,
they may not be ideal for your specific application. For
optimum performance, review all parameters and reset
those that are not optimum for your application.
The parameters of the Extended Menu are divided into
seven groups, identified below.
Parameter groups:
0 Operation and Display
1 Load and Motor
2 References and Limits
3 Functions and Timers
4 Inputs and Outputs
5 Serial Data Interface
6 Service and Diagnostics

Parameter Numbers

Each parameter number consists of three digits. The digit
to the left indicates the group. In each group, parameters
are numbered from 0 and up. For example, the
parameters in group 1 are numbered 100, 101, 102, etc.

Accessing the Various Parameters

When initially powered up, the display is in the Display
mode. Press "Menu" and "+" simultaneously to go to the
Extended Menu. The flashing number at the left of the
second line of the display identifies the group accessed.
Use the "+" and "–" keys to scroll through the menu
groups. Press "Menu" again to access a specific
parameter within a group. The flashing number will now
be at the parameter within the group. Use the "+" and "–"
keys to scroll through the list of parameter numbers.
54

Changing the Parameter Data Value

When a parameter has been selected and the data value
is to be changed, press the "Data" key and then "+" or
"–". The data value can be either a number or text. For
numeric values, the digit to be changed can be selected
by pressing the "Data" key as required. If a parameter in
the current set is changed, the parameter change
immediately affects the drive's operation. The Data mode
is exited by pressing "Menu" or by waiting 20 seconds.
The selected data value will then be saved to the
EEPROM.
000-099
100-199

Leaving Data Mode

200-299 The data value is stored by pressing "Menu".
300-399
400-499
500-599
600-699
VLT
NOTE: The motor must be stopped before the
data values of certain parameters are changed.
®
Series 3500