Danfoss VLT AutomationDrive FC 301 Programming Manual page 60

Parameter Descriptions
Application
Low inertia applications
High inertia applications
3 3
High load at low speed
Table 3.12 Recommendations for Flux Applications
Adjust starting torque in parameter 1-66 Min. Current at Low
Speed. 100% provides nominal torque as starting torque.
58
®
VLT AutomationDrive FC 301/302
Settings
Keep calculated values.
Parameter 1-66 Min. Current at Low
Speed.
Increase speed to a value between
default and maximum depending on
application.
Set ramp times matching the
application. Too fast ramp-up causes
an overcurrent/overtorque. Too fast
ramp-down causes an overvoltage
trip.
Parameter 1-66 Min. Current at Low
Speed.
Increase speed to a value between
default and maximum depending on
application.
Danfoss A/S © 01/2018 All rights reserved. MG33MO02