Danfoss VLT AutomationDrive FC 301 Programming Manual page 142

Parameter Descriptions
8-45 BTM Transaction Command
Option:
3 3
[0] Off
*
[1] Start Transaction
[2] Commit transaction
[3] Clear error
8-46 BTM Transaction Status
Option:
[0] Off
*
[1] Transaction Started
[2] Transaction Comitting
[3] Transaction Timeout
[4] Err. Non-existing Par.
[5] Err. Par. Out of Range
[6] Transaction Failed
[7] SO Config Check
[8] SO Config Check Done
8-47 BTM Timeout
Range:
60 s [1 - 360 s] Select the BTM timeout after a BTM
*
8-48 BTM Maximum Errors
Range:
21 [0 - 21] Selects the maximum allowed number of bulk
*
8-49 BTM Error Log
Range:
0.255 [0.000 -
*
9999.255]
140
Function:
NOTICE
This parameter cannot be
adjusted while the motor is
running.
Function:
transaction has been started.
Function:
transfer mode errors before aborting. If it is set to
maximum, there is no abort.
Function:
List of parameters that failed during
bulk transfer mode. The value after the
decimal break is the fault code (255
stands for no error).
Danfoss A/S © 01/2018 All rights reserved.
®
VLT AutomationDrive FC 301/302
Function:
MG33MO02