Danfoss VLT AutomationDrive FC 301 Programming Manual page 101

Parameter Descriptions
NOTICE
[224] Position Error
This option is available only with
software version 48.XX.
The position error exceeds the value in
parameter 4-71 Maximum Position Error for
the time set in parameter 4-72 Position
Error Timeout.
NOTICE
[225] Position Limit
This option is available only with
software version 48.XX.
The position is outside the limits set in
parameter 3-06 Minimum Position and
parameter 3-07 Maximum Position.
NOTICE
[226] Touch on
Target
This option is available only with
software version 48.XX.
Target position is reached in touch probe
position mode.
NOTICE
[227] Touch
Activated
This option is available only with
software version 48.XX.
Touch probe positioning active. The
frequency converter monitors the touch
probe sensor input.
[231] In Power Lim.
Mot.
[232] In Power Lim.
Gen.
[233] In Power Limit
5-30 Terminal 27 Digital Output
Option: Function:
[0] No operation Functions are described in parameter group
*
5-3* Digital Outputs.
5-31 Terminal 29 Digital Output
Option: Function:
NOTICE
This parameter is applicable for FC 302
only.
[0] No operation Functions are described in parameter group
*
5-3* Digital Outputs.
5-32 Term X30/6 Digi Out (MCB 101)
Option:
[0] No operation
[1] Control Ready
[2] Drive ready
MG33MO02
Programming Guide
Function:
This parameter is active when
®
option module VLT General
Purpose I/O MCB 101 is mounted
in the frequency converter.
Functions are described in
parameter group 5-3* Digital
Outputs.
Danfoss A/S © 01/2018 All rights reserved.
5-32 Term X30/6 Digi Out (MCB 101)
Option: Function:
[3] Drive rdy/rem ctrl
[4] Enable / no warning
[5] Running
[6] Running / no warning
[7] Run in range/no warn
[8] Run on ref/no warn
[9] Alarm
[10] Alarm or warning
[11] At torque limit
[12] Out of current range
[13] Below current, low
[14] Above current, high
[15] Out of speed range
[16] Below speed, low
[17] Above speed, high
[18] Out of feedb. range
[19] Below feedback, low
[20] Above feedback, high
[21] Thermal warning
[22] Ready,no thermal W
[23] Remote,ready,no TW
[24] Ready, Voltage OK
[25] Reverse
[26] Bus OK
[27] Torque limit & stop
[28] Brake, no brake war
[29] Brake ready, no fault
[30] Brake fault (IGBT)
[31] Relay 123
[32] Mech brake ctrl
[33] Safe stop active
[38] Motor feedback error
[39] Tracking error
[40] Out of ref range
[41] Below reference, low
[42] Above ref, high
[43] Extended PID Limit
[45] Bus ctrl.
[46] Bus ctrl, 1 if timeout
[47] Bus ctrl, 0 if timeout
[50] On Reference
[55] Pulse output
[60] Comparator 0
[61] Comparator 1
[62] Comparator 2
[63] Comparator 3
[64] Comparator 4
[65] Comparator 5
[70] Logic rule 0
[71] Logic rule 1
[72] Logic rule 2
[73] Logic rule 3
3 3
99