Fast-Reroute (Te Interface Configuration Mode) - Cisco Nexus 7000 Series Command Reference Manual

fast-reroute (TE interface configuration mode)

fast-reroute (TE interface configuration mode)
To enable an Multiprotocol Label Switching (MPLS) traffic engineering (TE) tunnel to request a backup
tunnel to protect against a link or node failure, use the fast-reroute command. To restore the system to
its default condition, use the no form of this command.
Syntax Description
bw-protect
node-proteect
Defaults
None
Command Modes
TE interface configuration mode
Supported User Roles network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines
This command requires the MPLS Services license.
Examples
This example shows how to specify bandwidth protection:
switch# configure terminal
switch(config)# interface tunnel-te 1000
switch(config-if-te)# fast-reroute bw-protect
switch(config-if-te)#
This example shows how to specify node protection:
switch# configure terminal
switch(config)# interface tunnel-te 1000
switch(config-if-te)# fast-reroute node-protect
switch(config-if-te)#
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
150
fast-reroute [bw-protect] [node-protect]
no fast-reroute
(Optional) Sets the bandwidth protection desired bit so that backup
bandwidth protection is requested at each hop that the label switched path
(LSP) traverses.
(Optional) Sets the node protection desired bit so that node protection is
requested at each hop the LSP traverses.
Modification
This command was introduced.
F Commands
OL-24994-01