Bridge-Domain - Cisco Nexus 7000 Series Command Reference Manual

bridge-domain

bridge-domain
To enter bridge-domain configuration mode and configure a bridge domain, use the bridge-domain
command. To remove the bridge-domain configurations, use the no form of this command.
Syntax Description
domain-id
Defaults
None
Command Modes Global configuration mode
Supported User Roles network-admin
vdc-admin
Command History Release
6.2.2
Usage Guidelines Removing the bridge-domain configuration does not remove the underlying VLAN. If a VLAN is
associated with a bridge domain, you cannot remove the VLAN without first removing the bridge
domain. To remove the underlying VLAN, use the no vlan command after you remove the bridge
domain.
This command requires the MPLS Services license.
Examples
This example shows how to enter bridge-domain configuration mode and configure a bridge domain:
switch# configure terminal
switch(config)# bridge-domain 10
switch(config)#
This example shows how to remove the bridge-domain configuration including port associations:
switch(config)# no bridge-domain 10
switch(config)#
Related Commands Command
system bridge-domain Identifies the IDs that are available for bridge-domain configurations.
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
120
bridge-domain domain-id
no bridge-domain domain-id
Bridge-domain ID. The range is defined by the system-bridge-domain
configuration.
Modification
This command was introduced.
Description
B Commands
OL-24994-01