Ip Rsvp Signalling Hello Reroute State-Timeout Refresh Interval - Cisco Nexus 7000 Series Command Reference Manual

I Commands

ip rsvp signalling hello reroute state-timeout refresh interval

To configure the interval in which Resource Reservation Protocol (RSVP) hello mesages are sent to
support the HST functionality, use the ip rsvp signalling hello reroute state-timeout refresh interval
command. To return to the default settings, use the no form of this command.
Syntax Description
value
Defaults
2 seconds for HST.
200 milli seconds for fast-reroute.
Command Modes Interface configuration mode
Supported User Roles network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines
The same form of the command with the fast-reroute keyword may be used to configure the number of
missed consecutive hello messages before a neighbor is declared down for fast reroute functionality in
a future phase.
This command requires the MPLS Services license.
Examples This example shows how to configure the interval in which RSVP hello message are sent to support the
HST functionality:
switch# configure terminal
switch(config)# interface ethernet 2/2
switch(config-if)# ip rsvp signalling hello reroute state-timeout refresh interval 12
Related Commands Command
mpls ldp configuration Configures the Multiprotocol Label Switching (MPLS) Label Distribution
OL-24994-01
ip rsvp signalling hello reroute state-timeout refresh interval time
no ip rsvp signalling hello reroute state-timeout refresh misses time
Maximum number of messages allowed in the receive window. The range is
from 1 to 64.
Modification
This command was introduced.
Description
Protocol (LDP).
ip rsvp signalling hello reroute state-timeout refresh interval
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
197