Cisco Nexus 7000 Series Command Reference Manual page 177

M Commands
mdt data
To configure a range of group addresses that are used for data multicast distribution trees (MDTs), use
the mdt data command.
Syntax Description
mdt-group-prefix
threshold
threshold-value
route-map
policy-name
Defaults The default value for the threshold parameter is 100 kbps
Command Modes
Configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines This command requires the MPLS Services license.
Examples
This example shows how to configure the the range of group address used for data MDTs:
switch# config t
Enter configuration commands, one per line.
switch(config)# vrf context vrf1
switch(config-vrf)# mdt data 232.7.7.0/24 threshold 10 route-map rmap2mdt data
239.192.20.32 0.0.0.15 threshold 1
switch(config-vrf)#
Related Commands Command
show mvpn mdt route
OL-24994-01
mdt data mdt -group-prefix [threshold threshold-value] [route-map policy-name]
List of group range prefixes.
(Optional) Specifies the threshold in kilobits per second.The range is from
0 to 4294967.
Threshold in bytes per second when the stream is switched to the data MDT.
Specifies the route map for creating data MDTs. The map can be a
case-sensitive alphanumeric string up to 63 characters.
Policy file that defines which customer data streams should be considered
for switching to the data MDT.
Modification
This command was introduced.
Description
Displays the detail of the default and the MDT route.
End with CNTL/Z.
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
mdt data
1129