Cisco Nexus 7000 Series Command Reference Manual page 242

protection fast-reroute
protection fast-reroute
To enable a Multiprotocol Label Switching (MPLS) traffic engineering (TE) tunnel to request a backup
tunnel to protect against a link or node failure, use the fast-reroute command. To restore the system to
its default condition, use the no form of this command.
Syntax Description
bw-protect
Command Modes
LSP attribute configuration mode
Supported User Roles network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines
This command requires the MPLS Services license.
Examples
This example shows how to enable failure protection on the LSP:
switch# configure terminal
switch(config)# mpls traffic-eng configuration
switch(config-te)# lsp attributes 1
switch(config-lsp-attr)# protection fast-reroute
switch(config-te-lsp-attr)#
Related Commands Command
mpls traffic-eng
configuration
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
1194
protection fast-reroute [bw-protect]
no protection fast-reroute
(Optional) Sets the bandwidth protection desired bit so that backup
bandwidth protection is requested at each hop that the LSP traverses.
Modification
This command was introduced.
Description
Configures the Multiprotocol Label Switching (MPLS) Traffic Engineering
Protocol (MPLS-TE).
P Commands
OL-24994-01