Cisco Nexus 7000 Series Command Reference Manual page 428

timers throttle lsa
timers throttle lsa
To set rate limiting for link-state advertisement (LSA) generation, use the timers throttle lsa command.
To return to the default setting, use the no form of this command.
Syntax Description
start-interval
hold-interval
max-interval
Defaults The defaults are as follows:
•
•
•
Command Modes Router configuration mode
Supported User Roles network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines
This command requires the MPLS Services license.
Examples This example shows how to set rate limiting for LSA generation:
switch# configure terminal
switch(config)# feature ospf
switch(config)#
switch(config-router)# timers throttle lsa 1 500 600
switch(config-router)#
Related Commands Command
mpls ldp configuration Configures the Multiprotocol Label Switching (MPLS) Label Distribution
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
1224
timers throttle lsa start-interval hold-interval max-interval
no timers throttle lsa start-interval hold-interval max-interval
Start interval. The range is from 0 to 5000 milliseconds.
Hold interval. The range is from 50 to 30000 milliseconds.
Max interval. The range is from 50 to 30000 miliiseconds.
start-interval— The default is 0.
hold-interval— The default is 5000.
max-interval— The default is 5000.
Modification
This command was introduced.
test1
Description
Protocol (LDP).
T Commands
OL-24994-01