Forwarding-Adjacency - Cisco Nexus 7000 Series Command Reference Manual

forwarding-adjacency

forwarding-adjacency
To advertise a traffic engineering (TE) tunnel as a link in an Interior Gateway Protocol (IGP) network,
use the forwarding-adjacency command. To return to the default setting, use the no form of this
command.
Syntax Description
holdtime
value
Defaults Default value is 0
Command Modes TE tunnel configuration mode
Supported User Roles network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines This command requires the MPLS Services license.
Examples This example shows how to advertise the TE tunnel as a link in an IGP network:
switch# configure terminal
switch(config)# interface tunnel-te 1
switch(config-if-te)# forwarding-adjacency holdtime 1
switch(config-if-te)#
Related Commands Command
interface tunnel-te
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
164
forwarding-adjacency [holdtime value]
no forwarding-adjacency
(Optional) Specifies the time, in milliseconds, that a TE tunnel waits after
going down before informing the network.
(Optional) Hold time. The range is from 0 to 4294967295.
Modification
This command was introduced.
Description
Configures the traffic engineering (TE) interface.
F Commands
OL-24994-01