Disable-Peer-As-Check - Cisco Nexus 7000 Series Command Reference Manual

D Commands

disable-peer-as-check

To disable checking the peer autonomous system number (ASN) during route advertisement, use the
disable-peer-as-check command.
Syntax Description This command does have any arguments or keywords.
Defaults
None
Command Modes
config-router-vrf-neighbor-af mode
Supported User Roles network-admin
vdc-admin
Command History Release
6.2.2
Usage Guidelines
This command requires the MPLS Services license.
Examples This example shows how to disable checking the peer ASN during a route advertisement:
switch# configure terminal
switch(config)# feature bgp
switch(config)# feature-set mpls
switch(config)# feature mpls l3vpn
switch(config)# feature bgp
switch(config)# router bgp 1.1
switch(config-router)# neighbor 33.0.1.63 remote-as 100
config-router-vrf-neighbor)# address-family ipv4 unicast
switch(config-router-neighbor-af)# neighbor 33.0.1.63 remote-as 100
switch(config-router-vrf-neighbor)# address-family ipv4 unicast
switch(config-router-vrf-neighbor-af)# disable-peer-as-check
switch(config-router-vrf-af)#
Related Commands Command
address-family ipv4
unicast
OL-24994-01
disable-peer-as-check
Modification
This command was introduced.
Description
Enters address family configuration mode for configuring routing sessions
that use standard IPv4 address prefixes.
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
disable-peer-as-check
133