Ip Unnumbered Loopback - Cisco Nexus 7000 Series Command Reference Manual
Nx-os mpls
Hide thumbs
Also See for Nexus 7000 Series:
- Command reference manual (1018 pages) ,
- Reference manual (746 pages) ,
- Configuration manual (536 pages)
Table of Contents
Advertisement
ip unnumbered loopback
ip unnumbered loopback
To enable IP processing on an interface without assigning an explicit IP address to the interface, use the
ip unnumbered loopback command. To restore the system to its default condition, use the no form of
this command.
Syntax Description
number
Defaults
None
Command Modes
TE interface configuration mode
Supported User Roles
network-admin
vdc-admin
Command History
Release
5.2(1)
Usage Guidelines
This command is not effective until you configure the specified loopback with an IP address.
This command does not require an MPLS Services license.
Examples
This example shows how to configure an interface as an unnumbered loopback:
switch# configure terminal
switch(config)# interface tunnel-te 1
switch(config-if-te)# ip unnumbered loopback 0
switch(config-if-te)#
Related Commands
Command
tunnel-te interface
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
198
ip unnumbered loopback number
no ip unnumbered loopback number
Virtual interface number. The range is from 0 to 1023.
Modification
This command was introduced.
Description
Configures the traffic engineering (TE) interface.
I Commands
OL-24994-01
Advertisement
Table of Contents
