Internetworking - Cisco Nexus 7000 Series Command Reference Manual

internetworking

internetworking
To specify the type of pseudowire and the type of traffic that can flow across the network, use the
internetworking command.
Syntax Description ethernet
vlan
Defaults None
Command Modes config-xconnect configuration mode
Supported User Roles network-admin
vdc-admin
Command History Release
6.2.2
Usage Guidelines This command is required only if you are configuring a connection between two disparate attachment
circuits.
•
•
•
This command requires the MPLS Services license.
Examples
This example shows how to specify the type of pseudowire and the type of traffic that can flow across
the network:
switch# configure terminal
switch(config)# interface ethernet 4/0/0.1
switch(config-if)# encapsulation dot1q 100
switch(config-if)# l2vpn xconnect context Test1
switch(config-xconnect)# internetworking ethernet
switch(config-xconnect)#
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
178
internetworking {ethernet | vlan}
Specifies the Ethenet type.
Specified the VLAN type.
Modification
This command was introduced.
The internetworking type on a provider edge (PE) device must match the internetworking type on
its peer PE device.
The ethernet keyword causes Ethernet frames to be extracted from the attachment circuit and sent
over the pseudowire. Ethernet end-to-end transmission is assumed. Attachment circuit frames that
are not Ethernet are dropped.
The vlan keyword allows the VLAN ID to be included as part of the Ethernet frame.
I Commands
OL-24994-01