Cisco Nexus 7000 Series Command Reference Manual page 231

P Commands
ping mpls
To test the Multiprotocol Label Switching (MPLS) label switched path (LSP) reachability, use the ping
mpls command.
Syntax Description ipv4
destination-address
destination-mask-length Target FEC address with the mask length.
pseudowire
ipv4-address
vc-id
traffic-eng
tunnel-te
interface number
Defaults None
Command Modes EXEC mode
Supported User Roles
network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines This command requires the MPLS Services license.
Examples This example shows how to specify the test MPLS LSP reachability:
switch# ping mpls pseudowire 1.2.3.4 200
LSP ping for VCCV is not supported
switch(config)#
This example shows how to specify an LDP IPv4 prefix FEC for validation:
switch# ping mpls ipv4 10.131.191.252/32 repeat 5 exp 5 verbose
Sending 5, 100-byte MPLS Echos to 10.131.191.252/32,
OL-24994-01
ping mpls {ipv4 destination-address/destination-mask-length | pseudowire ipv4-address vc-id |
traffic-eng tunnel-te interface number}
Specifies the target as an IPv4 address.
Target Forwarding Equivalence Class (FEC) address.
Specifies the target virtual channel (VC) as an IPv4 address and VC ID.
IPv4 address.
VC ID. The range is from 0 to 4294967295.
Specifies as a traffic engineering (TE) tunnel interface.
Specifies the TE interface.
TE interface number. The range is from 0 to 65503.
Modification
This command was introduced.
timeout is 2 seconds, send interval is 0 msec:
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
ping mpls
1183