Cisco Nexus 7000 Series Command Reference Manual page 210

mpls traffic-eng attribute-flags
mpls traffic-eng attribute-flags
To set the user-defined interface attribute flags, use the mpls traffic-eng attribute-flags command. To
return to the default setting, use the no form of this command.
Syntax Description
value
Defaults None
Command Modes Interface configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines This command requires the MPLS Services license.
Examples This example shows how to set the user-defined interface attribute flags:
switch# configure terminal
switch(config)# interface ethernet 6/1
switch(config-if)# mpls traffic-eng attribute-flags 0x3f
switch(config)#
Related Commands Command
interface tunnel-te
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
1162
mpls traffic-eng attribute-flags value
no mpls traffic-eng attribute-flags
Attribute flags. Typically entered in the range 0x0 - 0xffffffff.
Modification
This command was introduced.
Description
Configures the traffic engineering (TE) interface.
M Commands
OL-24994-01