Inherit Port-Profile - Cisco Nexus 7000 Series Command Reference Manual

I Commands

inherit port-profile

To apply an existing pseudowire port profile to an interface, use the inherit port-profile command.
Syntax Description
profile-name
Defaults None
Command Modes config-if-pseudowire configuration mode
Supported User Roles network-admin
vdc-admin
Command History Release
6.2.2
Usage Guidelines An interface can inherit only an active pseudowire port profile. To enable a pseudowire port profile, use
the state enabled command.
This command requires the MPLS Services license.
Examples This example shows how to apply an existing port profile to an interface:
switch# configure terminal
switch(config)# port-profile type pseudowire AToM
switch(config-if-prof)# encapsulation mpls
switch(config-pseudowire-mpls)# interface pseudowire 100
switch(config-if-prof)# inherit port-profile AToM
Related Commands Command
interface pseudowire
port-profile type
pseudowire
state enabled
OL-24994-01
inherit port-profile profile-name
Profile name. The string can be any alphanumeric string up to 63 characters.
Modification
This command was introduced.
Description
Enters interface pseudowire configuration mode and configures a static
pseudowire logical interface.
Enters interface port-profile configuration mode and configures a
pseudowire port profile.
Enables the interface port profile.
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
inherit port-profile
177