Explicit-Path - Cisco Nexus 7000 Series Command Reference Manual

explicit-path

explicit-path
To configure an IP explicit path to be used by tunnel-te label switched path (LSPs), or a path dynamically
calculated from the TE topology database, use the explicit-path command. To restore the system to its
default condition, use the no form of this command.
Syntax Description
name
path-name
identifier
number
Defaults None
Command Modes
TE configuration mode
Supported User Roles network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines
This command requires the MPLS Services license.
Examples
This example shows how to configure the tunnel to use a named IP explicit path or a path dynamically
calculated from the TE topology database:
switch# configure terminal
switch(config)# mpls traffic-eng configuration
switch(config-te)# explicit-path name avoid-protected-link
switch(config-te-expl-path)#
Related Commands Command
mpls traffic-eng
configuration
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
148
explicit-path {name path-name | identifier number}
no explicit-path {name path-name | identifier number}
Specifies the explicit path by name.
Path name. The maximum size is 63 alphanumeric characters.
Specifies the explicit path by number.
Identifier number. The range is from 1 to 65535.
Modification
This command was introduced.
Description
Configures the Multiprotocol Label Switching (MPLS) Traffic Engineering
Protocol (MPLS-TE).
E Commands
OL-24994-01