Cisco Nexus 7000 Series Command Reference Manual page 212

mpls traffic-eng bandwidth
mpls traffic-eng bandwidth
To allocate the Multiprotocol Label Switching (MPLS) traffic engineering (TE) bandwidth pool for the
interface, use the mpls traffic-eng bandwidth command. To restore the system to its default condition,
use the no form of this command.
Syntax Description
interface-kbps
percentage
percentage
Defaults If neither interface-kbps nor a percentage are specified, then the bandwidth pool size defaults to 75% of
the interface's bandwidth.
Command Modes Interface configuration mode
Supported User Roles network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines
This command requires the MPLS Services license.
Examples This example shows how to allocate the MPLS TE bandwidth pool for the interface:
switch# configure terminal
switch(config)# interface ethernet 2/1
switch(config-if)# mpls traffic-eng bandwidth 1000
switch(config-if)#
Related Commands Command
interface tunnel-te
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
1164
mpls traffic-eng bandwidth [interface-kbps | percent percentage]
no mpls traffic-eng tunnels
(Optional) Maximum amount of bandwidth (in kbps) that can be allocated
by TE flows. The range is from 1 to 10000000.
(Optional) Specifies the maximum percentage of the link bandwidth that
may be allocated by TE flows.
(Optional) The range is from 1 to 100.
Modification
This command was introduced.
Description
Configures the traffic engineering (TE) interface.
M Commands
OL-24994-01