Cisco Nexus 7000 Series Command Reference Manual page 187

M Commands
member encapsulation mpls
To specify the devices that form a point-to-point Layer 2 VPN (L2VPN) Virtual Forwarding Interface
(VFI) connection, use the member encapsulation mpls command.
Syntax Description ip-address
Defaults
None
Command Modes config-l2vpn-vfi mode
Supported User Roles network-admin
vdc-admin
Command History Release
6.2.2
Usage Guidelines
This command requires the MPLS Services license.
Examples This example shows how to specify the devices that form a point-to-point L2VPN VFI connection:
sswitch# configure terminal
switch(config)# l2vpn vfi context vpls80
switch(config-l2vpn-vfi)# description VFIforDualHome
switch(config-l2vpn-vfi)# vpn 10
switch(config-l2vpn-vfi)# redundancy primary
switch(config-l2vpn-vfi)# member 10.0.0.3 encapsulation mpls
switch(config-l2vpn-vfi)#
Related Commands Command
bridge domain
l2vpn vfi context
vpn
OL-24994-01
member ip-address encapsulation mpls
IPv4 or IPv6 address.
Modification
This command was introduced.
Description
Enters bridge-domain configuration mode and configures a bridge domain.
Establishes a Layer 2 VPN (L2VPN) Virtual Forwarding Interface (VFI)
between two or more separate networks.
Configures a Virtual Private Network (VPN) ID on a VFI context.
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
member encapsulation mpls
1139