Cisco Nexus 7000 Series Command Reference Manual page 216

mpls traffic-eng router-id
mpls traffic-eng router-id
To specify that the traffic engineering router identifier for the node is the IP address associated with a
given interface, use the mpls traffic-eng router-id command. To return to the default setting, use the no
form of this command.
Syntax Description
interface
Defaults
Enable
Command Modes Router configuration mode
Supported User Roles network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines This command is not effective until you configure the specified loopback with an IP address.
This command requires the MPLS Services license.
Examples This example shows how to configured the TE router-ID to be the IP address of the loopback 0 interface:
switch(config)# router isis
switch(config-router)# mpls traffic-eng router-id loopback0
switch(config-router)#
Related Commands Command
interface tunnel-te
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
1168
mpls traffic-eng router-id interface
no mpls traffic-eng router-id interface
Virtual interface number. The range is from 0 to 1023.
Modification
This command was introduced.
Description
Configures the traffic engineering (TE) interface.
M Commands
OL-24994-01