Cisco Nexus 7000 Series Command Reference Manual page 337

Show Commands
show ip rsvp sender
To display the Resource Reservation Protocol (RSVP) path status, use the show ip rsvp sender
command.
Syntax Description destination
ip-address
sender
ip-address
dst-port
port
src-port
port
detail
Defaults None
Command Modes EXEC mode
Supported User Roles
network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines This command requires the MPLS Services license.
Examples This example shows how to display the detailed RSVP path status:
switch# show ip rsvp sender detail
PATH:
Tun Dest: 10.10.0.6 Tun ID: 100 Ext Tun ID: 10.10.0.1
Tun Sender: 10.10.0.1 LSP ID: 31
Path refreshes:
arriving: from PHOP 10.10.7.1 on Et0/0 every 30000 msecs
Session Attr:
Setup Prio: 7, Holding Prio: 7
Flags: (0x7) Local Prot desired, Label Recording, SE Style
OL-24994-01
show ip rsvp sender [destination ip-address] [sender ip-address] [dst-port port] [src-port port]
[detail]
(Optional) Specifies the path based on a destination IP address.
Destination IP address.
(Optional) Specifies the path based on a source IP address.
Source IP address.
(Optional) Specifies the path based on a destination port.
Destination port value. The range is from 0 to 2147483647.
(Optional) Specifies the path based on a source port.
Source port value. The range is from 0 to 2147483647.
(Optional) Specifies the detailed RSVP status.
Modification
This command was introduced.
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
show ip rsvp sender
1259