Exp - Cisco Nexus 7000 Series Command Reference Manual

Nx-os mpls
Hide thumbs Also See for Nexus 7000 Series:
Table of Contents

Advertisement

E Commands

exp

To configure the EXP bits that are forwarded over the member tunnel, use the exp command.
Syntax Description
list -of-exp-values
default
Defaults
The member tunnel will forward the packets with the EXP bits that are not being forwarded by other
member tunnels that are part of the same bundle.
Command Modes
cbts-member configuration mode
Supported User Roles
network-admin
vdc-admin
Command History
Release
5.2(1)
Usage Guidelines
You cannot configure the following traffic engineering (TE) commands on a class-based tunnel selection
(CBTS) member tunnels (auto-bw; autoroute; backup-bw; description; destination;
fowarding-adjacency; inherit; source).
This command requires the MPLS Services license.
Examples
This example shows how to configure the EXP bits that are forwarded over the member tunnel:
switch# configure terminal
switch(config)# interface tunnel-te 1
switch(config-if-te)# cbts-member tunnel-te 251
switch(config-cbts-member)# exp 5
Related Commands
Command
interface tunnel-te
OL-24994-01
exp [list-of-exp-values] [default]
EXP bits allowed for the interface. Enter up to eight EXP values separated
by spaces. Values range from 0 to 7. The default is the EXP values that were
not configured or a specific member tunnel.
(Optional) Specifies the default tunnel number.
Modification
This command was introduced.
Description
Configures the traffic engineering (TE) interface.
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
exp
145

Advertisement

Table of Contents
loading

Table of Contents