Cisco Nexus 7000 Series Command Reference Manual page 429

T Commands
topology
To configure the Multiprotocol Label Switching (MPLS) topology database, use the topology command.
Syntax Description
holddown
sigerr
sec
Defaults None
Command Modes
TE configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines This command requires the MPLS Services license.
Examples
This example shows how to specify the link hold down time for signalling errors:
switch# configure terminal
switch(config)# mpls traffic-eng configuration
switch(config-te)# topology holddown sigerr 200
switch(config-te)#
Related Commands Command
mpls traffic-eng
configuration
OL-24994-01
topology holddown sigerr sec
Specifies the topology database hold down timers.
Specifies the link hold down time for signalling errors.
Holddown time in seconds. The range is from 0 to 300.
Modification
This command was introduced.
Description
Configures the Multiprotocol Label Switching (MPLS) Traffic Engineering
protocol (MPLS-TE).
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
topology
1225