Cisco Nexus 7000 Series Command Reference Manual page 154

load-interval
load-interval
To configure the interval over which the input and output rates for the interface are averaged, use the
load-interval command. To restore the system to its default condition, use the no form of this command.
Syntax Description
seconds
Defaults
300
Command Modes Interface configuration mode
Supported User Roles network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines For a tunnel-te interface, the bandwidth command configures the initial tunnel bandwidth, which then can
be adjusted by the auto bandwidth mechanism based on interface traffic statistics The load-interval command
specifies how often the interface traffic statistics are calculated.
Examples This example shows how to configure the interval over which the input and output rates for the interface
are averaged:
switch# configure terminal
switch(config)# interface tunnel-te 1
switch(config-if-te)# load-interval 180
switch(config-if-te)#
Related Commands Command
interface tunnel-te
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
1114
load-interval seconds
no load-interval
Length of time for which data is used to compute load statistics. The value
is a multiple of 30, from 120 to 300 (120, 150, 180, and so on).
Modification
This command was introduced.
Description
Configures the traffic engineering (TE) interface.
L Commands
OL-24994-01