Cisco Nexus 7000 Series Command Reference Manual page 150

link-management timers
link-management timers
To configure the link management hold timers, use the link-management timers command. To return
to the default setting, use the no form of this command.
Syntax Description
bandwidth-hold
sec
period-flooding
sec
Defaults
Bandwidth hold is 15 seconds
Periodic flooding is 60 seconds
Command Modes TE configuration mode
Supported User Roles network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines This command requires the MPLS Services license.
Examples This example shows how to configure the link management bandwidth hold timer:
switch# configure terminal
switch(config)# mpls traffic-eng configuration
switch(config-te)# link management timers bandwidth-hold 200
switch(config-te)#
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
1110
link-management timers {bandwidth-hold sec | periodic-flooding sec}
no link-management timers
Specifies the length of time that bandwidth is held for an RSVP path (setup)
message while you wait for the corresponding RSVP Resv message to come
back.
Seconds. The range is from 1 to 300 seconds.
Specifies the link state information changes that do not trigger immediate
action. For example, a change to the amount of allocated bandwidth that
does not cross a threshold.
Seconds. The range is from 0 to 3600 seconds. A value of 0 turns off
periodic flooding. If you set this value from 1 to 29, it is treated as 30.
Modification
This command was introduced.
L Commands
OL-24994-01