Cisco Nexus 7000 Series Command Reference Manual page 257

R Commands
rewrite ingress tag push dot1q symmetric
To add one VLAN tag to the incoming dot1q frame and symmetrically apply the operation to the ingress
and egress frames, use the rewrite ingress tag push dot1q symmetric command.
Syntax Description vlan-id
Defaults
None
Command Modes config-if-srv mode
Supported User Roles network-admin
vdc-admin
Command History Release
6.2.2
Usage Guidelines
The VLAN ID must match the domain ID of the bridge domain to which this Ethernet Flow Point (EFP)
is to be associated.
This command is supported only on an EFP that you configured with the encapsulation default
command.
This command requires the MPLS Services license.
Examples This example shows how to add one VLAN tag to the incoming dot1q frame and symmetrically apply
the operation to the ingress and egress frames:
switch# configure terminal
switch(config)# interface ethernet 2/1
switch(config-if)# no ip address 10.1.1.1 255.255.255.0
switch(config-if)# service instance 1 ethernet
switch(config-if-srv)# description EFP1forTest
switch(config-if-srv)# encapsulation dot1q 10
switch(config-if-srv)# rewrite ingress tag push dot1q 30 symmetric
switch(config-if-srv)#
OL-24994-01
rewrite ingress tag push dot1q vlan-id symmetric
VLAN ID. The range is from 2 to 967.
Modification
This command was introduced.
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
rewrite ingress tag push dot1q symmetric
1209