Cisco Nexus 7000 Series Command Reference Manual page 290

signalling rate-limit
signalling rate-limit
To rate limit the number of messages being sent to a neighboring router, use the signalling rate-limit
command. To return to the default settings, use the no form of the command.
Syntax Description
interval
msec
limit
messages
Defaults
The default are as follows:
•
•
Command Modes RSVP configuration mode
Supported User Roles network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines
This command requires the MPLS Services license.
Examples This example shows how to rate limit the number of messages that are being sent to a neighboring router:
switch(config)# ip rsvp
switch(config-ip-rsvp)# signalling rate-limit interval 300
switch(config-ip-rsvp)#
Related Commands Command
mpls ldp configuration Configures the Multiprotocol Label Switching (MPLS) Label Distribution
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
1222
signalling rate-limit {[interval msec] [limit messages]}
no signalling rate-limit {[interval msec] [limit messages]}
(Optional) Specifies the scheduling interval.
Interval in milliseconds. The range is from 250 to 2000.
(Optional) Specifies the message limit per scheduling interval.
Message limit value. The range is from 1 to 500.
Interval— The default is 1000.
Limit— The default is 100.
Modification
This command was introduced.
Description
Protocol (LDP).
S Commands
OL-24994-01