Cisco Nexus 7000 Series Command Reference Manual page 168

logging tunnel reroute
logging tunnel reroute
To configure the generation of system logs when a TE tunnel's reroute pending state changes, use the
logging tunnel reroute command. To stop logging these system messages, use the no form of the command.
Syntax Description This command has no arguments or keywords.
Command Modes TE interface configuration (config-te-if)
TE global configuration (config-te).
Supported User Roles network-admin
vdc-admin
Command History Release
7.3(0)D1(1)
Usage Guidelines No system message is logged if this feature is not configured.
This feature can be configured either for an individual TE tunnel or all the TE tunnels.
Reroute pending state change messages are not logged if the tunnel exits reroute pending state by going
down.
Examples This example shows how to configure system logs for all TE tunnels when their reroute pending state
changes.
switch# configure terminal
switch(config)# mpls traffic-eng configuration
switch(config-te)# logging tunnel reroute
switch(config-te)#
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
1128
logging tunnel reroute
no logging tunnel reroute
Modification
This command was introduced.
L Commands
OL-24994-01