Cisco Nexus 7000 Series Command Reference Manual page 215

M Commands
mpls traffic-eng level
To configure the Multiprotocol Label Switching (MPLS) traffic engineering (TE) for Intermediate
System-to-Intermediate System (IS-IS), use the mpls traffic-eng level command. To return to the default
setting, use the no form of this command.
Syntax Description
level-1
level-1-2
level-2
Defaults Enable
Command Modes
Router configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines You can enable MPLS for level-1, level-2 or level 1 and level-2 routers.
This command requires the MPLS Services license.
Examples
This example shows how to configure MPLS TE for IS-IS:
switch(config)# router isis p1
switch(config-router)# mpls traffic-eng level-1
switch(config-router)#
Related Commands Command
interface tunnel-te
OL-24994-01
mpls traffic-eng {level-1 | level-1-2 | level-2}
no mpls traffic-eng {level-1 |level-1-2 | level-2}
Specifies MPLS TE on IS-IS level-1 only.
Specifies MPLS TE on IS-IS level-1 and level-2.
Specifies MPLS TE on IS-IS level-2 only.
Modification
This command was introduced.
Description
Configures the traffic engineering (TE) interface.
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
mpls traffic-eng level
1167