Cisco Nexus 7000 Series Command Reference Manual page 254

reoptimize timers
reoptimize timers
To configure Multiprotocol Label Switching (MPLS) traffic engineering reoptimize timers, use the
reoptimize timers command
Syntax Description
delay
cleanup
sec
installation
sec
frequency
sec
Defaults
The default are as follows:
•
•
•
Command Modes TE configuration mode
Supported User Roles network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines This command requires the MPLS Services license.
Examples This example shows how to delay the replacement of the current LSP by the reoptimized LSP:
switch# configure t
switch(config)# mpls traffic-eng configuration
switch(config-te)# reoptimize timers delay installation 3000
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
1206
.
To return to the default setting, use the no form of this command.
reoptimize timers {delay cleanup sec | installation sec | frequency sec}
no reoptimize timers {delay cleanup | installation | frequency}
Specifies the delay reoptimization action.
Specifies to delay the cleanup of the reoptimized LSP.
Time in seconds to delay the cleanup of the replaced tunnel LSP. The range
is from 0 to 60.
Specifies to delay the replacement of the current LSP by the reoptimized
LSP.
Time in seconds to delay the replacement of the tunnel LSP. The range is
from 0 to 3600.
Specifies the interval between reoptimization scans.
Time in seconds between reoptimizations. The range is from 0 to 604800.
Delay cleanups— The default is 10.
Installation— The default is 3.
frequency— The default is 3600.
Modification
This command was introduced.
R Commands
OL-24994-01