Auto-Bw Timers - Cisco Nexus 7000 Series Command Reference Manual

auto-bw timers

auto-bw timers
To enable automatic bandwidth adjustment on a platform and begin sampling the output rate for tunnels
that have been configured for automatic bandwidth adjustment, use the auto-bw timers command. To
restore the system to its default condition, use the no form of this command.
Syntax Description
frequency
seconds
Defaults
When the optional frequency keyword is not specified, the sampling interval is 300 seconds (5 minutes).
Command Modes Traffic engineering global configuration mode
Supported User Roles network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines
The bandwidth command configures the initial tunnel bandwidth, which is adjusted by the auto
bandwidth mechanism.
This command requires the MPLS Services license.
Examples This example shows how to enable automatic bandwidth adjustment on a platform that has been
configured for automatic bandwidth adjustment:
switch# configure terminal
switch(config)# mpls traffic-eng configuration
switch(config-te)# auto–bw timers frequency 600
switch(config-te)#
Related Commands Command
mpls traffic-eng
configuration
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
126
auto-bw timers [frequency seconds]
no auto-bw timers [frequency seconds]
(Optional) Specifies how often tunnel-te output rates should be
(Optional) Interval in seconds, for sampling the output rate of each tunnel
configured for automatic bandwidth. The range is 1 through 604800. The
recommended value is 300.
Modification
This command was introduced.
Description
Configures the Multiprotocol Label Switching (MPLS) Traffic Engineering
Protocol (MPLS-TE).
A Commands
sampled.
OL-24994-02