Cisco Nexus 7000 Series Command Reference Manual page 287
Nx-os mpls
Hide thumbs
Also See for Nexus 7000 Series:
- Command reference manual (1018 pages) ,
- Reference manual (746 pages) ,
- Configuration manual (536 pages)
Table of Contents
Advertisement
S Commands
signalling initial-retransmit-delay
To configure the minimum amount of time that Resource Reservation Protocol (RSVP) waits for an
acknowledgment before retransmitting the same message, use the signalling initial-retransmit-delay
command. To return to the default settings, use the no form of this command.
Syntax Description
time
Defaults
1 second
Command Modes
RSVP configuration mode
Supported User Roles
network-admin
vdc-admin
Command History
Release
5.2(1)
Usage Guidelines
This command requires the MPLS Services license.
Examples
This example shows how to configure the minimum amount time that RSVP waits for an
acknowledgment before retransmitting the same message:
switch(config)# ip rsvp
switch(config-ip-rsvp)# signalling initial-retransmit-delay 4
switch(config-ip-rsvp)#
Related Commands
Command
mpls ldp configuration Configures the Multiprotocol Label Switching (MPLS) Label Distribution
OL-24994-01
signalling initial-retransmit-delay time
no signalling initial-retransmit-delay time
Hello interval in seconds.The range is from 2000 to 300000.
Modification
This command was introduced.
Description
Protocol (LDP).
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
signalling initial-retransmit-delay
1219
Advertisement
Table of Contents
