Cisco Nexus 7000 Series Command Reference Manual page 335

Show Commands
show ip rsvp reservation
To display detailed Resource Reservation Protocol (RSVP) reservations, use the show ip rsvp
reservation command.
Syntax Description destination
ip-address
sender
dst-port
port
src-port
detail
Defaults
None
Command Modes EXEC mode
Supported User Roles network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines
This command requires the MPLS Services license.
Examples This example shows how to display the detailed RSVP reservation status:
switch# show ip rsvp reservation detail
Reservation:
Tun Dest: 10.1.1.1 Tun ID: 1 Ext Tun ID: 172.16.1.1
Tun Sender: 172.16.1.1 LSP ID: 104
Next Hop: 172.17.1.2 on Eth1/0
Label: 18 (outgoing)
Reservation Style is Shared-Explicit, QoS Service is Controlled-Load
Average Bitrate is 0 bits/sec, Maximum Burst is 1K bytes
Min Policed Unit: 0 bytes, Max Pkt Size: 0 bytes
RRO:
172.18.1.1/32, Flags:0x1 (Local Prot Avail/to NHOP)
Label subobject: Flags 0x1, C-Type 1, Label 18
OL-24994-01
show ip rsvp reservation [destination ip-address] [sender ip-address] [dst-port port] [src-port
port] [detail]
(Optional) Specifies the destination IP address information.
IP address.
(Optional) Specifies the source IP address information.
(Optional) Specifies the destination port information.
(Optional) Destination port value. The range is from 0 to 2147483647.
(Optional) Specifies the source port information.
(Optional) Specifies the detailed RSVP status.
Modification
This command was introduced.
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
show ip rsvp reservation
1257