Manually Assigning Ip Information To Multiple Svis - Cisco Catalyst 9500 Manual

Manually Assigning IP Information to Multiple SVIs

Command or Action
to NVRAM May Cause You to No longer Automatically
Download Configuration Files at Reboot^C
Step 5 end
Example:
Device(config-if)# end
Step 6
show boot
Example:
Device# show boot
Manually Assigning IP Information to Multiple SVIs
This task describes how to manually assign IP information to multiple switched virtual interfaces (SVIs):
SUMMARY STEPS
1. enable
2. configure terminal
3. interface vlan vlan-id
4. ip address ip-address subnet-mask
5. exit
6. ip default-gateway ip-address
7. end
8. show interfaces vlan vlan-id
9. show ip redirects
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Device> enable
Step 2 configure terminal
Example:
Device# configure terminal
System Management Configuration Guide, Cisco IOS XE Fuji 16.8.x (Catalyst 9500 Switches)
66
Performing Device Setup Configuration
Purpose
Returns to privileged EXEC mode.
Verifies the configuration.
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.