Commissioning; Operation; Maintenance; Maintenance Work - Festo MS6-SV D-10V24 Series Instructions Manual

Commissioning

Designations
S1 Proximity sensor S1
S2 Proximity sensor S2
S3 Proximity sensor S3
V1 Pilot valve 1
V2 Pilot valve 2
Pot.-free Potential-free contact
Emergency stop Emergency stop (input circuit)
Feedback loop Feedback circuit
Safety device Safety relay unit or safety PLC
Digital output Digital output
Digital input Digital input
Standard PLC Programmable logic controller
Tab. 7 Designations in circuit examples
8 Commissioning
The product does not have its own control logic and must therefore be integrated into the control sys-
tem through appropriate measures.
Graphic display of commissioning è Fig.3.
Proceed as follows to commission the product:
• Apply operating pressure p1
Ä The product is now ready for operation and can be actuated.
The filling speed of the pneumatic system can be adjusted with the flow control valve è Fig.2.
9

Operation

Perform a forced switch-off at least once a month if the process-related switching frequency is lower.
10

Maintenance

10.1

Maintenance work

A dirty silencer can extend the time needed for exhausting the system and thus restrict the safety func-
tion.
• Check the silencer regularly and replace if necessary.
18 Festo — MS6-SV-...-D-10V24 — 2019-05b