Table of Contents
Advertisement
MAINTENANCE
HYDRAULIC BRAKES
Hydraulic Brake Fluid
In addition to the scheduled maintenance interval for changing the brake fluid,
the brake fluid must also be changed in the following conditions:
• fluid becomes contaminated
• fluid level falls BELOW the MIN mark
• the type/brand of fluid in reservoir is unknown
Replace the fluid according to instructions in the vehicle service manual or
take to your dealer.
Check Brake Fluid Level
NOTICE
1.
Park vehicle on a level surface.
2.
Check the brake fluid level at the reservoir. The fluid level should be
between the upper MAX and lower MIN lines.
3.
If the level is below the MAX line, add brake fluid:
a.
Clean any dirt and debris from around the reservoir cap.
b.
Remove cap from reservoir.
c.
Add fluid until it reaches the MAX line.
d.
Reinstall cap.
e.
Clean any spilled brake fluid from the area.
f.
Dispose of any unused fluid.
4.
Press and hold the brake pedal fully down for a few seconds.
5.
Check for fluid leakage around the fittings.
52
Always inspect the pedal travel before operating a
vehicle to confirm some brake function is present.
When adding or changing brake fluid, always use
brake fluid from an unopened bottle. After opening a
bottle of brake fluid, discard the unused portion. Do
not store or use from an opened bottle. Brake fluid
rapidly absorbs moisture from the air. The moisture
causes the boiling temperature of the brake fluid to
drop. This can lead to premature brake fade and the
risk of accident that can result in severe injury or
death.
The brake fluid reservoir is under the cowl at the passen-
ger's side front wheel.
Advertisement
Table of Contents
