Wheel Installation; Light Bulb Replacement - Ezgo MPT 800 2004 Owner's Manual And Service Manual

Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
If the tire is flat, remove the wheel and inflate the tire to
the maximum recommended pressure for the tire.
Immerse the tire in water to locate the leak and mark with
chalk. Insert tire plug in accordance with manufacturer's
instructions.
!
machine is anchored to floor. Wear OSHA approved
safety equipment when mounting/demounting tires.
If the tire is to be removed or mounted, the tire changing
machine manufacturer's recommendations must be fol-
lowed in order to reduce possibility of severe injury.

Wheel Installation

To reduce the possibility of component
damage, do not tighten lug nuts to more
than 85 ft. lbs. (115 Nm) torque.
It is important to follow the 'cross sequence'
pattern when installing lug nuts. This will
assure even seating of the wheel against the hub.
With the valve stem to the outside, mount the wheel onto
the hub with lug nuts. Finger tighten lug nuts in a 'cross
sequence' pattern (Ref. Fig. 18 on page 13). Tighten lug
nuts to 50 - 85 ft. lbs. (70 - 115 Nm) torque in 20 ft. lbs.
(30 Nm) increments following the 'cross sequence' pat-
tern.
Tire/wheel style
may vary
'Cross Sequence'
1
4
Ref Whi 2
Fig. 18 Wheel Installation
To reduce the possibility
!
of severe injury, be sure
mounting/demounting
'Cross Sequence'
1
3
3
2
5 2
Owner's Manual and Service Guide
O P E R A T I O N A N D S E R V I C E I N F O R M A T I O N

LIGHT BULB REPLACEMENT

with bare fingers. Use clean, dry tissue or paper towel to handle
the glass portion of the bulb.
For vehicles with headlights mounted in cowl, locate the
two screws on backside of cowl that secure headlight
(Ref. Fig. 19 on page 13). Remove screws, pull headlight
out and disconnect wires. Connect wires to new head-
light, install in cowl and secure with screws previously
removed.
Headlight
Bulb
Ref Hdr 2
Fig. 19 Headlight and Turn Signal Bulb Replacement
To replace the turn signal light bulb, support turn signal
housing from backside of cowl while removing two
screws securing lens. Install new bulb and replace lens.
To replace the tail and brake light bulb, roll the rubber
bezel from around the edge of the taillight and remove
lens. Install replacement bulb and replace lens.
4
Ref Tlr 2
Fig. 20 Tail and Brake Light Bulb Replacement
To reduce the possibility of premature
bulb failure, do not touch new bulbs
Turn Signal Lens
Inside
of Cowl
Turn Signal
Housing
Roll Rubber
Bezel Away
From Body
Tail/Brake
Light
Rear
Fender
Page 13