Snmp-Server Community - Dell Networking 2024 Reference Manual

DVMRP Traps................................. Disable
OSPFv2 Traps................................ Disable
PIM Traps................................... Disable
OSPFv3 Traps................................ Disable
FIP snooping Traps.......................... Enable
Example #2
console#show trapflags ospf
OSPF Traps:
errors:
all..............................Disabled
authentication failure...........Enabled
bad packet.......................Enabled
config error.....................Enabled
virt authentication failure .....Disabled
virt bad packet..................Disabled
virt config error................Disabled
if-rx: if-rxpacket...............Disabled
lsa: lsamaxage...................Disabled
lsaoriginate.....................Disabled
overflow: lsdboverflow...........Enabled
lsdb-approaching-overflow........Enabled
retransmit:
packets..........................Disabled
virtpackets......................Disabled
rtb: rtb-entryinfo...............Disabled
state-change:
all..............................Disabled
if state change..................Enabled
neighbor state change............Enabled
virtif state change..............Disabled
virtneighbor state change........Disabled

snmp-server community

Use the snmp-server community command in Global Configuration mode to
set up the community access string to permit access to the SNMP protocol.
To remove the specified community string, use the no form of this command.
Syntax
string view-name
snmp-server community {ro | rw | su} [view ][ipaddress
ipaddress
]
string
no snmp-server community
1617
SNMP Commands