Thermo Scientific Dionex ICS-5000 Operator's Manual page 97

Switched AC Sockets
The two AC receptacles can be used to control the power to external devices.
Use Chromeleon to switch the power on and off. TTL inputs can also be used
to control the AC sockets (see
Fuse Holder, Main Power Switch, and Power Receptacle
The fuse holder contains two 10-amp slow-blow fuses (P/N 954772). For
instructions on how to change the fuses, see
The rear panel power switch is the main power switch for the DC. Turn on the
main power switch before initial operation and leave the switch on unless
instructed to turn it off (for example, before performing a service procedure).
NOTE
For routine on/off control, use the
of the DC (see
hold the
The power cord plugs into the IEC 320 three-prong receptacle.
The power supply cord is used as the main disconnect device. Make
sure the socket-outlet is located near the DC and is easily accessible.
Le cordon d'alimentation principal est utilisé comme dispositif principal
de débranchement. Veillez à ce que la prise de base soit située/installée
près du module et facilement accessible.
Das Netzkabel ist das wichtigste Mittel zur Stromunterbrechung. Stellen
Sie sicher, daß sich die Steckdose nahe am Gerät befindet und leicht
zugänglich ist.
USB Connections
The USB (Universal Serial Bus) receptacle ("B" type connector) allows
connection to the PC on which Chromeleon software is installed.
The two USB ports ("A" type connectors) allows connection to other USB
devices in the system (for example, the pump and eluent generator).
A 1.8 m (6 ft) USB cable (P/N 960777) is included in the DC Ship Kit
(P/N 072011).
Doc. 065342-06 12/11
Section
Figure 2-16). To turn off the DC, press and
POWER
button for 2 seconds.
2 • DC Description
2.17.4).
Section 9.22.
POWER
button on the front
81