Thermo Scientific Dionex ICS-5000 Operator's Manual page 229

TC-Related Audit Trail Error Message
The counter [name] (value: x) has exceeded its
limit (y). Module should no longer be used.
Replace the [name].
The data format stored on the chip card is
unsupported (format version x).
The injections limit for the column has been
exceeded.
The injections limit will be exceeded for the
column x.
The nominal temperature must be set within the
current limits.
The nominal temperature value is out of range
defined by the active column ID.
The oven is not fully operable yet. Check the
values of "Standby," "Ready," "Door," and
"CardState."
The primary column ID property "x" will be
changed. The property can't be changed in the
future.
The upper limit must be higher than the lower
limit.
The Warning threshold must be higher than the
Limit threshold.
The Warning threshold must be lower than the
Limit threshold.
There was already an AcqOff command for this
channel before.
There was already an AcqOn command for this
channel before.
This function cannot be adjusted by the user.
This operation may affect the oven's operation
on timebase x, which is currently running a
batch.
Doc. 065342-06 12/11
Table 8-4. TC Error Messages (Continued)
8 • Troubleshooting
Default See
Severity
Level
Warning page 293
Error page 293
Warning page 294
Warning page 294
Error page 294
Error page 294
Error page 294
Warning page 295
Error page 295
Error page 296
Error page 296
Warning page 296
Warning page 296
Abort page 297
Warning page 297
213