Thermo Scientific Dionex ICS-5000 Operator's Manual page 311

To troubleshoot:
1. Open the Chromeleon 7 ePanel Set or the Chromeleon 6.8 panel tabset.
2. Press the F8 key to open the Commands dialog box.
3. Check the status of each property listed in the error message. The table
below indicates the status required for operation.
Command
CardState
Door
Ready
Standby
4. When you identify the component that is not ready for operation, find and
eliminate the cause of the problem.
The primary column ID property "x" will be changed. The property
can't be changed in the future.
This error occurs when you modify a primary column property (batch or lot
number, date of manufacture, etc.). To prevent any unintended changes,
Chromeleon requests confirmation before saving the new property.
To troubleshoot:
If you are sure that the proposed change is correct, go ahead and save it.
The upper limit must be higher than the lower limit.
This error occurs if the value entered for a parameter's upper limit (for
example, TC_Temp.Signal.UpperLimit) is less than the lower limit for the
parameter.
To troubleshoot:
Increase the value of the upper limit setting.
Doc. 065342-06 12/11
Status
OK
Closed
Ready
NoStandby
8 • TC Troubleshooting
295