Thermo Scientific Dionex ICS-5000 Operator's Manual page 128

Dionex ICS-5000 Operator's Manual
In Chromeleon 6.8, the raw 3D amperometry data plot can be viewed as either
an Iso or a 3D (wireframe) plot. For both plot types, colors are used to
represent the ranges of response values.
The Iso view is the default view for the 3D raw data. This is a top down view
of the data (imagine you are looking down on the data from above the plot)
(see Figure
waveform period (ms). The z-axis, which is represented by different colors in
the plot, is the response (nA).
Figure 2-58. 3D Amperometry Data in Chromeleon 6.8: Iso View
NOTE
The 3D data shown in Figures
using an analytical waveform (see
Waveforms" on page
To switch to the 3D plot view, right-click on the Iso plot, select Decoration
and click the Iso/3D Plot tab. The 3D view projects the response values in the
third dimension, which allows you to see the height of responses as well as the
colors representing different magnitudes of detection signal along the z-axis
112
2-58). The x-axis is the retention time (min) and the y-axis is the
retention time (min)
108).
z
y
2-58 and 2-59 were collected
"Analytical vs. Scanning
x
Doc. 065342-06 12/11