Thermo Scientific Dionex ICS-5000 Operator's Manual page 273

2. Check that the EG main power switch (on the rear panel) is turned on.
3. Check that the main power cord is plugged into both the EG rear
panel connector and the power source. Check that the wall outlet has
power.
4. Check the USB connections. The EG should be connected to the
DP/SP (or other Dionex ICS-5000 module) via a USB cable
(P/N 960777). In addition, one module in the system must be
connected to the PC on which Chromeleon is installed.
5. Check that the EG is configured in Chromeleon and is assigned to an
instrument (Chromeleon 7) or timebase (Chromeleon 6.8).
Doc. 065342-06 12/11
8 • EG Troubleshooting
257