Thermo Scientific Dionex ICS-5000 Operator's Manual page 38

Dionex ICS-5000 Operator's Manual
Button/LED
Label
CONNECTED
ALARM
PUMP 1 FLOW*
PUMP 2 FLOW**
PUMP 1 PRIME
PUMP 2 PRIME
POWER
* Pump 1 is always installed in the lower half of the DP/SP enclosure.
** This button is not present on the SP.
22
If the LED Is On
The DP/SP is connected to
a Chromeleon 7 instrument
or Chromeleon 6.8
timebase.
A DP/SP-related problem
has occurred (for example,
a pressure limit was
activated). Check the
Chromeleon Audit Trail for
the cause.
Use the FLOW button to
start and stop the pump
flow. The LED indicates
when the flow is on.
* Use the PRIME button to
** prime the pump (see
Section 9.5).
The LED indicates whether
the pump is being primed.
Use this POWER button for
routine on/off control of the
DP/SP. When the power is
on, this LED is lighted. To
turn off the DP/SP, press
and hold this POWER
button for 2 seconds.
Note: The main power
switch is on the rear panel.
If the LED Is Flashing
Does not flash.
Does not flash.
Does not flash.
The pump is being primed.
Does not flash.
Doc. 065342-06 12/11