Thermo Scientific Dionex ICS-5000 Operator's Manual page 227

TC-Related Audit Trail Error Message
Error finishing download.
Error programming flash memory.
Executing this command will reset associated
counter values stored in the module.
Firmware download failed.
Firmware download in progress. Please wait.
Gas leak detected.
Humidity leak detected.
Illegal parameter.
Invalid date/time format. Either use "DD MMM
YYYY" or "current [ + [Nyear[s]] [Nmonth[s]]
[Nday[s]]]." Examples: "31 Dec 1999," "current +
1year 6months."
Invalid enumerated value.
Next qualification of this module is due in x
day(s) (due date is [date]).
Next qualification of this module is overdue (due
date was [date]).
Next qualification of this module is overdue (due
date was [date]). Module may no longer be used.
Next qualification of this module was due on
[date]. Allowing x more grace day(s).
Next service of this module is due in x day(s)
(due date is [date]).
Next service of this module is overdue (due date
was [date]).
No chip card in the reader for the column x.
No response from x for x seconds.
No response from x for x seconds. Device
disconnected.
Doc. 065342-06 12/11
Table 8-4. TC Error Messages (Continued)
8 • Troubleshooting
Default See
Severity
Level
Abort page 277
Abort page 284
Warning page 284
Abort page 285
Error page 285
Error page 285
Error page 285
Abort page 286
Error page 286
Warning page 286
Warning page 286
Warning page 287
Error page 287
Warning page 287
Warning page 287
Warning page 287
Error page 288
Warning page 288
Abort page 288
211