Thermo Scientific Dionex ICS-5000 Operator's Manual page 62

Dionex ICS-5000 Operator's Manual
One 1.8 m (6 ft) USB cable (P/N 960777) is provided in the EG Ship Kit
(P/N 072047).
Fuse Holder, Main Power Switch, and Power Receptacle
The fuse cartridge contains two 2-amp slow-blow fuses (P/N 954773). For
instructions on how to change the fuses, see
The rear panel power switch is the main power switch for the EG. Turn on the
main power switch before initial operation and leave it on unless instructed to
turn it off (for example, before performing a service procedure).
NOTE
For routine on/off control, use the
of the EG (see
the
The power cord plugs into the IEC 320 three-prong receptacle.
The power supply cord is used as the main disconnect device. Make
sure the socket-outlet is located near the EG and is easily accessible.
Le cordon d'alimentation principal est utilisé comme dispositif principal
de débranchement. Veillez à ce que la prise de base soit située/installée
près du module et facilement accessible.
Das Netzkabel ist das wichtigste Mittel zur Stromunterbrechung. Stellen
Sie sicher, daß sich die Steckdose nahe am Gerät befindet und leicht
zugänglich ist.
Tubing Chase
The tubing chase routes tubing from the front of the EG, through the interior
of the module, and to the rear panel.
Suppressor, Vent, and Drain Lines
•
The lines exiting the tubing chase (white tubing) are for connecting the
REGEN IN
Modifier to the
•
The gas vent line (clear tubing) discharges the electrolysis gas (H
that is vented from the electrolyte reservoir of the EGC.
46
Figure 2-8). To turn off the EG, press and hold
POWER
button for 2 seconds.
port on the RFIC Eluent Degasser or EPM III Electrolytic pH
REGEN OUT
Section 9.18.
POWER
button on the front
port on the suppressor.
or O )
2 2
Doc. 065342-06 12/11