DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
The Network Monitoring commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
show packet ports
show error ports
show utilization
clear counters
clear log
show log
enable syslog
disable syslog
show syslog
create syslog host
config syslog host
delete syslog host
show syslog host
clear green-ethernet
show green-ethernet
Each command is listed in detail, as follows:
show packet ports
Purpose
Syntax
Description
Parameters
55
NETWORK MONITORING COMMANDS
Parameter
<portlist>
<portlist>
[ports | cpu]
{index <value>}
<index 1-4> ipaddress <ipaddr> {severity [informational | warning | all] | facility
[local0 | local1| local2 | local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number>}
[all | <index 1-4>] {severity [informational | warning | all] | facility [local0 | local1 |
local2 | local3 | local4 | local5 | local6 | local7] | udp_port <udp_port_number> |
ipaddress <ipaddr>}
[<index 1-4> | all]
{<index 1-4>}
Cumulative_Energy_Saved
To display statistics about the packets sent and received in frames
per second by the Switch.
show packet ports <portlist>
The show packet ports command displays statistics about packets
sent and received by ports specified in the port list. The results are
separated into three tables, labeled A, B, and C in the window
below. Table A is relevant to the size of the packets, Table B is
relevant to the type of packets and Table C is relevant to the type of
frame associated with these packets.
<portlist> − A port or range of ports whose statistics are to be
8